How to Set a Hanging Indent for References in Word

Open your Word document (.docx) in Cue Office, select your reference entries, and set a 0.5-inch left indent and a 0.5-inch hanging indent in Format → Paragraph…. Each first line starts at the left margin and each wrapped line starts half an inch farther in.

Select the three references

This rain garden field report ends with three sample references. Select from the start of the first entry, Allen, through the end of the last entry, Chen & Rivera, leaving the References heading and the two preceding body paragraphs unselected.

Original rain garden report, with the first lines and wrapped lines of references aligned along the same left edge
Before formatting, the first and wrapped lines of all three references start at the same margin.

Set the left indent and hanging depth

Open Format → Paragraph… and go to Indents and Spacing. Set Left indent to 0.5″, choose Hanging under Special, confirm that By is set to 0.5″, and click OK.

Indents and Spacing tab of the Paragraph dialog box, with Left indent and By set to 0.5 inches and Special set to Hanging
Set Left indent and By to 0.5 inches, and choose Hanging under Special.

The left indent sets the position of the wrapped lines. The hanging indent pulls the first line back by the same distance. This aligns the author names with the References heading and the left margin of the body text above.

If you only select Hanging under Special but leave Left indent at 0, the first line extends left of the body text in this report. If that happens, open the Paragraph dialog again and check both values.

Reopen the file and test a new wrapped line

Use File → Save As… to save a copy, then close and reopen it. Use the References heading as a guide. The first lines should still align with it, and the wrapped lines should sit half an inch farther in.

Manually formatted document saved and reopened, showing the first lines of the three references aligned with the References heading and subsequent lines indented
After saving as a copy and reopening, the first line of each reference remains aligned with the heading, while subsequent lines stay indented.

In the copy, add an explanatory sentence to the end of the last reference. In this example, the third entry grew from two lines to three. The new line follows the same indent as the line above it. Indentation is a paragraph-level setting, so text will wrap naturally as you edit entries.

Last reference entry wrapping naturally across three lines after appending a sentence, with both subsequent lines indented
After adding a sentence to the end of the last entry, the new wrapped line aligns with the existing indented line.

Ask Cue AI to adjust only these three references

Open the unformatted report and instruct Cue AI to format only the three entries under References, specifying where the first and subsequent lines should start.

Before sending, check that Track changes below the Cue AI input is on (the button is blue). This switch is part of the Cue AI pane.

Please format the three source entries beneath References so their first lines stay at the left margin and any wrapped lines sit half an inch farther in. Apply this only to those three entries. Keep the headings, body, and all wording as they are.

Cue AI updated the formatting for the three reference paragraphs. Save a copy, close it, and reopen it. Check that the first lines align with the margin, the wrapped lines sit farther in, and the headings, body, and reference text match the original. The red bars in the margin mark the tracked formatting changes in this copy.

AI result saved and reopened, showing references with flush-left first lines, indented wrapped lines, and red formatting revision bars in the margin
The reopened copy still shows the hanging indents. The red bars mark tracked formatting changes.

Practice with the rain garden field report

Expand full example

Below is the complete demonstration report and three references. Keep each entry as a single paragraph, select from the first entry to the last, and practice indenting the subsequent lines.

Rain garden field report

After the May storms, volunteers checked three rain gardens on Ash Street. Water collected near two inlets, where fallen leaves had blocked the curb openings.

Before the next heavy rain, clear both openings and record how long the water takes to drain.

References

Allen, M. (2024). Mapping runoff at neighborhood rain gardens: A field guide to recording puddles, changes in soil moisture, and drainage after storms. Green Streets Press.

Bennett, R. (2025). A maintenance calendar for small rain gardens: Seasonal checks for overflow paths, planting beds, and street-side water inlets. Urban Waters Lab.

Chen, A., & Rivera, L. (2026). Tracking the first year of a rain garden: How volunteer teams can collect and compare observations across several blocks. Civic Ecology Notes.
Manually formatted document saved and reopened, showing the first lines of the three references aligned with the References heading and subsequent lines indented
After saving as a copy and reopening, the first line of each reference remains aligned with the heading, while subsequent lines stay indented.

Check the inspection tasks and references before sharing

Once the references are in place, ask Cue AI to turn the body text into a reminder for the next inspection. Check that it says to clear both blocked inlets first, then time how long the water takes to drain after rain. When you add a new monitoring reference, check where its first line and wrapped lines start.

Store your inspection findings and references in a Word document (.docx), and record drainage times across the three gardens in Excel (.xlsx). When presenting to volunteers, use a single PowerPoint (.pptx) slide to show which inlets were blocked and what to monitor next time. Cue Office lets you open and edit all three file formats for free. If you share the report as a PDF, use the free PDF reader to check the alignment of the references on the last page. Download Cue Office for free